Deutsch 
English 
For Photobooth Ready units built from 2023 onwards, a short video shows the calibration step by step: video “Calibrating the touchscreen, Ready from 2023” (Dropbox, MP4).
Units built up to 2023 (ELO 1537L touchscreen)
- Check power and connection: The ELO touchscreen must be properly connected to the computer and switched on.
- Driver: The ELO Touch driver is stored on the computer under C:\installation (folder Elo-Touch). It is normally installed already.
- Open the calibration tool: Once the driver is installed, the ELO calibration tool is available via the Control Panel or Start menu.
- Start calibration: The tool guides you through the process with on-screen instructions. Touch the displayed points one after the other.
- Test: Afterwards open a few applications and check that the screen responds precisely to touch.
- Troubleshooting: If the touchscreen is still inaccurate, repeat the calibration or consult the help section on the ELO website.
Check the calibration regularly, especially after transport. Further answers are available in the help centre.
Applies to: Photobooth Ready 1.1
Last updated: February 2024
Was this helpful?
All questions in the help centre
More questions about Photobooth Ready
- The camera keeps losing its connection to the PC. What is the cause?
- The software says the licence needs to be renewed. Is my licence expiring?
- Where do I find the settings for sharing photos via QR code?
- How can I use an iPad as an additional screen?
- Parts of my layout are cropped when printing. What can I do?
- The camera clicks before the shot, focuses and only fires one or two seconds later. How do I avoid the first click?